Jorge Martinez de Salinas

In a previous post we talked about RIP. Today I’m going to show you how to configure OSPF. OSPF is a dynamic link-state routing protocol used in IP networks. OSPF is perhaps the most widely used interior gateway protocol (IGP) in large enterprise networks. OSPF exceeds RIP in many aspects:

• It has very low convergence times.
• When no topology changes occur, OSPF is very quiet.
• OSPF enables network subdivision into areas.
• Supports authentication.
• Uses multicast.
• Only routing changes are propagated, not the full routing table like in the RIP case.
• …

To configure OSPF in your cisco router you should follow these steps:

fry> enable 
fry# configure terminal 
fry(config)#router ospf 1 
fry(config-router)#network 192.168.2.0 0.0.0.255 area 0 
fry(config-router)#network 192.168.3.0 0.0.0.255 area 0
fry(config-router)#network 192.168.4.0 0.0.0.255 area 0

You have to specify all the interfaces in which you want to run OSPF with network commands. 0.0.0.255 is a wildcard and means that OSPF will run in any interface with an IP address belonging to the 192.168.2.0/24 network. You can also indicate a specific IP address. If the interface’s IP address changes (e.g. from 192.168.4.1 to 192.168.4.2), OSPF will stop running. The configuration is as follows:

fry(config-router)#network 192.168.4.1 0.0.0.0 area 0

To propagate a default route you can execute this command:

fry(config-router)#default-information originate always

One OSPF drawback could be the configuration complexity. However, if the network topology is point-to-point and we only have one area (like in this case) configuration is pretty straightforward.

Routing Information Protocol (RIP) is an Interior gateway protocol that uses the distance-vector routing algorithm. The original specification of RIP, defined in RFC 1058, uses classful routing. The periodic routing updates do not carry subnet information, lacking support for variable length subnet masks (VLSM). RIPv2 introduces VLSM support, multicast and authentication capabilities. Although RIP has important limitations (slow convergence times, 15 hop limit, full routing updates periodically…) it’s very easy to configure and can come in handy for some networks. To configure RIP in your cisco router you should follow these steps:

router> enable 
router# configure terminal 
router(config)#router rip 
router(config-router)#network 192.168.2.0 
router(config-router)#network 192.168.3.0 
router(config-router)#network 192.168.4.0 
router(config-router)#version 2

You have to specify all the interfaces in which you want to run RIP with network commands. And that’s all. You have RIP running on your router. Note: In most current networking environments, RIP is not the preferred choice for routing as its capabilities are poor compared to EIGRP, OSPF, or IS-IS.